Ruijie RG-S2600G-I Series - Page 807

CLI Reference NFPP Configuration Commands
Command
mode
NFPP configuration mode.
Usage
guidelines
The scanning may occur on the condition that:
more than 15 packets are received within 10 seconds;
the source MAC address for the link layer is constant while
the source IP address is uncertain;
the source MAC and IP address for the link layer is
constant while the destination IP address is uncertain.
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard scan-threshold 20
Related
commands
Command
Description
nfpp arp-guard
scan-threshold
Set the scan threshold on the
port.
show nfpp arp-guard
summary
Show the configurations.
show nfpp arp-guard
scan
Show the ARP guard scan
table.
clear nfpp arp-guard
scan
Clear the ARP guard scan
table.
clear nfpp arp-guard hosts
Use this command to clear the monitored host isolation.
clear nfpp arp-guard hosts [vlan vid] [interface interface-id] [ip-address | mac-address]
Parameter
description
Parameter
Description
vid
Set the VLAN ID.
interface-id
Set the interface name and number.
ip-address
Set the IP address.
mac-address
Set the MAC address.
Default
Settings
N/A.