CLI Reference NFPP Configuration Commands
Set the rate limit for each source MAC
address.
Set the rate limit for each port.
Set the rate limit, in the range of
[1,9999]
The default rate limit for each source IP address and MAC address is
4pps; the default rate limit for each port is 100pps.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard rate-limit per-src-ip 2
Ruijie(config-nfpp)# arp-guard rate-limit per-src-mac 3
Ruijie(config-nfpp)# arp-guard rate-limit per-port 50
Set the rate limit and the
attack threshold.
show nfpp arp-guard
summary
arp-guard scan-threshold
Use this command to set the global scan threshold.
arp-guard scan-threshold pkt-cnt
Set the scan threshold, in the
range of 1-9999.
The default scan threshold is 15, in 10 seconds.
To Next Page
Loading...
