Ruijie RG-S2600G-I Series - Page 805

CLI Reference NFPP Configuration Commands
arp-guard monitored-host-limit number
Parameter
description
Parameter
Description
number
The maximum monitored host
number. The valid range is
1-4294967295.
Default
Settings
1000
Command
mode
NFPP configuration mode
Usage
guidelines
If the monitored host number has reached the default
1000, the administrator shall set the max-number smaller
than 1000 and it will prompt the message that %ERROR:The
value that you configured is smaller than current
monitored hosts 1000, please clear a part of monitored
hosts. to remind the administrator of the invalid
configuration and removing the monitored hosts.
When the maximum monitored host number has been
exceeded, it prompts the message that %
NFPP_ARP_GUARD-4-SESSION_LIMIT: Attempt to exceed limit
of 1000 monitored hosts.to remind the administrator.
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard monitored-host-limit 200
Related
commands
Command
Description
show nfpp arp-guard
summary
Show the configurations.
arp-guard rate-limit
Use this command to set the arp guard rate limit.
arp-guard rate-limit {per-src-ip | per-src-mac | per-port} pps
Parameter
description
Parameter
Description
per-src-ip
Set the rate limit for each source IP
address.