Ruijie RG-S2600G-I Series - Page 809

CLI Reference NFPP Configuration Commands
Related
commands
Command
Description
arp-guard
attack-threshold
Set the global attack threshold.
nfpp
arp-g
uard
polic
y
Set the attack threshold.
sho
w
nfpp
arp-g
uard
scan
Show the ARP scanning table.
nfpp arp-guard enable
Use this command to enable the anti-ARP attack function on the interface.
nfpp arp-guard enable
Parameter
description
Parameter
Description
-
-
Default
Settings
The anti-ARP attack function is not enabled on the interface.
Command
mode
Interface configuration mode.
Usage
guidelines
The interface anti-ARP attack configuration is prior to the
global configuration.
Examples
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp arp-guard enable
Related
commands
Command
Description
arp-guard enable
Enable the anti-ARP attack
function.