Ruijie RG-S2600G-I Series - Page 810

CLI Reference NFPP Configuration Commands
sho
w
nfpp
arp-g
uard
sum
mary
Show the configurations.
nfpp arp-guard isolate-period
Use this command to set the isolate period in the interface configuration mode.
nfpp arp-guard isolate-period {seconds | permanent}
Parameter
description
Parameter
Description
seconds
Set the isolate period, in second. The
valid range is 0, or [30, 86400]. 0
indicates no isolation.
permanent
Permanent isolation.
Default
Settings
By default, the isolate period is not configured.
Command
mode
Interface configuration mode.
Usage
guidelines
N/A
Examples
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp arp-guard isolate-period 180
Related
commands
Command
Description
arp-guard
isolate-period
Set the global isolate period.
show nfpp
arp-guard
summary
Show the configurations.