Ruijie RG-S2600G-I Series - Page 824

CLI Reference NFPP Configuration Commands
adopted; or the interface-based isolate period shall be
adopted.
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcpv6-guard isolate-period 180
Related
commands
Command
Description
nfpp dhcpv6-guard
isolate-period
Set the isolate time on the
interface.
show nfpp
dhcpv6-guard
summary
Show the configurations.
dhcpv6-guard monitor-period
Use this command to configure the monitor time.
dhcpv6-guard monitor-period seconds
Parameter
description
Parameter
Description
seconds
Set the monitor time, in seconds. The
valid range is [180, 86400].
Default
Settings
600s
Command
mode
NFPP configuration mode.
Usage
guidelines
 When the attacker is detected, if the isolate period is
0, the attacker will be monitored by the software and
the timeout time will be the monitor period. During the
software monitoring, if the isolate period is not 0, the
software-monitored attacker will be auto-isolated by
the hardware and the timeout time will be the isolate
period. The monitor period is valid with the isolate
period 0.
 If the isolate period has changed to be 0, the
attackers on the interface will be removed rather than
being monitored by the software.
Examples
Ruijie(config)# nfpp