CLI Reference NFPP Configuration Commands
dhcpv6-guard enable
Use this command to enable the DHCPv6 anti-attack function.
Dhcpv6-guard enable
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcpv6-guard enable
dhcpv6-guard isolate-period
Use this command to set the isolate time globally.
dhcpv6-guard isolate-period {seconds | permanent}
Set the isolate time, in seconds. The
valid range is 0, or [30, 86400].
The default isolate time is 0, which means no isolation.
The isolate period can be configured globally or based on
the interface. For one interface, if the isolate period is not
set based on the interface, the global value shall be
To Next Page
Loading...
