CLI Reference NFPP Configuration Commands
dhcpv6-guard attack-threshold
Use this command to set the global attack threshold. When the packet rate exceeds the attack threshold,
the attack occurs.
Dhcpv6-guard attack-threshold { per-src-mac | per-port} pps
Set the attack threshold for each
source MAC address.
Set the attack threshold for each port.
Set the attack threshold, in pps. The
valid range is [1,9999].
By default, the attack threshold for each source MAC address is
10pps; and the attack threshold for each port is 300pps.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcpv6-guard attack-threshold per-src-mac 15
Ruijie(config-nfpp)# dhcpv6-guard attack-threshold per-port 200
Show the rate-limit threshold
and attack threshold.
show nfpp
dhcpv6-guard summary
show nfpp
dhcpv6-guard hosts
Show the monitored host
list.
clear nfpp
dhcpv6-guard hosts
Clear the monitored host.
To Next Page
Loading...
