CLI Reference NFPP Configuration Commands
Set the attack threshold for each
source IP address.
Set the attack threshold for each port.
Set the attack threshold, in pps. The
valid range is [1,9999].
By default, the attack threshold for each source IP address and each
port are 20pps and 2000pps respectively.
The attack threshold shall be equal to or larger than the
rate-limit threshold.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# ip-guard attack-threshold per-src-ip 2
Ruijie(config-nfpp)# ip-guard attack-threshold per-port 50
Show the rate-limit threshold
and attack threshold.
show nfpp ip-guard
summary
Show the monitored host
list.
clear nfpp ip-guard
hosts
Clear the monitored host.
ip-guard enable
Use this command to enable the IP anti-scanfunction.
ip-guard enable
To Next Page
Loading...
