CLI Reference NFPP Configuration Commands
show nfpp log
Use this command to show the NFPP log configuration.
show nfpp log summary
Use this command to show the NFPP log buffer area content.
show nfpp log buffer [statistics]
Show the statistical information of
the NFPP log buffer area.
When the log buffer area is full, the subsequent logs are to
be dropped, and an entry with all attributes ”-” is displayed
in the log buffer area. The administrator shall increase the
capacity of the log buffer area or improve the rate of
generating the syslog.
The generated syslog in the log buffer area carries with
the timestamp, for example:
%NFPP_ARP_GUARD-4-DOS_DETECTED:
Host<IP=N/A,MAC=0000.0000.0004,port=Gi4/1,VLAN=1> was
detected.(2009-07-01 13:00:00)
The following example shows the NFPP log configurations:
Ruijie#show nfpp log summary
Total log buffer size : 10
Syslog rate : 1 entry per 2 seconds
Logging:
VLAN 1-3, 5
interface Gi 0/1
interface Gi 0/2
The following example shows the log number in the buffer area:
Ruijie#show nfpp log buffer statistics
There are 6 logs in buffer.
To Next Page
Loading...
