Ruijie RG-S2600G-I Series - Page 881

CLI Reference NFPP Configuration Commands
nfpp arp-guard
scan-threshold
Set the scan threshold.
show nfpp dhcp-guard hosts
Use this command to show the monitored host.
show nfpp dhcp-guard hosts [statistics | [[vlan vid] [interface interface-id] [ip-address |
mac-address]]]
Parameter
description
Parameter
Description
statistics
Show the statistical information of
the monitored host.
vid
The VLAN ID.
interface-id
The interface name.
ip-address
The IP address.
mac-address
The MAC address.
Default
Settings
N/A.
Command
mode
Privileged EXEC mode.
Usage
guidelines
N/A.
Examples
The following example shows the statistical information of the
monitored host:
Ruijie# show nfpp dhcp-guard hosts statistics
success fail total
------- ---- -----
100 20 120
The following example shows the monitored host:
Ruijie# show nfpp dhcp-guard hosts
If column 1 shows '*', it means "hardware failed to isolate host".
VLAN interface MAC address remain-time(seconds)
---- --------- ----------- -------------------
1 gi0/2 0000.0000.0001 10
*2 gi0/1 0000.0000.0002 20