Ruijie RG-S2600G-I Series - Page 953

CLI Reference Guide QoS Configuration Commands
Ruijie(config-if)# service-policy input po
Ruijie(config)# virtual-group 3
Ruijie(config-if)# service-policy input po
Related
commands
show mls qos interface.
Platform
description
The parameter output is not supported in the virtual-group.
priority-queue
Use this command to configure the output queue scheduling algorithm.
priority-queue
[no] priority-queue
Parameter
description
Parameter
Description
priority-queue
Set the output queue scheduling algorithm to
SP.
no priority-queue
Set the output queue scheduling algorithm to
WRR.
Default
configuration
The output queue scheduling algorithm is WRR.
Command
mode
Global configuration mode.
Examples
Ruijie(config)# no priority-queue
Related
commands
show mls qos queuing
53.2.8 priority-queue cos-map
Use this command to configure the associated CoS value of output queue:
priority-queue cos-map qid cos0 [cos1 [cos2 [cos3 [cos4 [cos5 [cos6 [cos7]
no priority-queue cos-map