CLI Reference Guide QoS Configuration Commands
By default, the physical port belongs to no virtual-group.
Interface configuration mode.
The member port joined the virtual group must be physical port or
Aggregate Port. The virtual group member ports must be in the same
line card(for the chassis-shaped switch) or in the same switch(for the
box-shaped switch). If the line card or switch has 48 ports, then all
member ports shall be distributed on the former 24 ports or the latter 24
ports.
The following example sets the interface gigabitEthernet 1/3 as the
member of virtual group 3:
Ruijie(config)# interface gigabitethernet 1/3
Ruijie(config-if)# virtual-group 3
Show the virtual-group settings.
The software version must be RGOS10.1 and higher.
show class-map
Use this command to show the information of class maps.
show class-map [class -name]
All class maps are shown by default.
To Next Page
Loading...
Need help?
General