CLI Reference Guide QoS Configuration Commands
Restore to the default value.
Global configuration mode.
Use this command to enable the queue to use sp+wfq schedule
algorithm, on the condition that the queue uses wfq schedule
algorithm.
The following example enables the queue to use wfq schedule
algorithm:
Ruijie(config)# mls qos scheduler wfq
Ruijie(config)# show mls qos scheduler
The following example configures queue 1 and queue 3 to use SP:
Ruijie(config)# wfq-queue 1 sp
Ruijie(config)# wfq-queue 3 sp
Ruijie(config)# show running
Show QOS schedule method.
The software version must be RGOS10.1 and higher.
virtual-group
Use this command to configure a physical port or Aggregate port as the member port of a virtual group. Use the
no form of this command to remove the member attribute of a virtual group on the port.
virtual-group virtual-group-number
no virtual-group virtual-group-number
Virtual group number, up to 128.
To Next Page
Loading...
Need help?
General