CLI Reference CFM Configuration Commands
Delete the service instance.
The maintenance association must be created before the creation of
the service instance, or it’ll fail to create the service instance.
Ruijie(config)#cfm service-instance 10 vlan 1 md MD_A ma MA_A_MD_A
Ruijie(config)#no cfm service-instance 10
show cfm
service-instance
Show the service instance information.
cfm mep-list service-instance
Use this command to set the MEP(maintenance association end point) list. The no form of this command can be
used to delete the MEP(maintenance association end point).
cfm mep-list mep-list service-instance instance-id
no cfm mep-list mep-list service-instance instance-id
The MEP list, which could be
one maintenance association
end point, or a series of
maintenance association end
points starting with the low ID
and ending with the high one
and using the “-“ to link both
IDs such as 10-20 . It is based
on the privileged view. The
valid range of the maintenance
association end point ID is
1-8191.
Service instance id, in the
range of 1-32767.
To Next Page
Loading...
Need help?
General