Ruijie RG-S2600G-I Series - Page 974

CLI Reference CFM Configuration Commands
Examples
Ruijie(config)#cfm cc service-instance 1 enable
Related
commands
Command
Description
cfm cc interval
service-instance
Set the interval of transmitting CCM.
show cfm mep
service-instance
Show the MEP (maintenance
association end point) information,
including the status of transmitting
CCM.
cfm alarm-priority service-instance mep
Use this command to configure the lowest bug level for MEP to generate the alarm. The no form of this command
can be used to restore the lowest bug level to the default value.
cfm alarm-priority priority-value service-instance instance-id [mep mep-id]
no cfm alarm-priority
Parameter
description
Parameter
Description
instance-id
Service instance id, in the range of
1-32767.
no
Restore the lowest bug level to the
default value.
mep-id
MEP ID, in the range of 1 to 8191.
priority-value
When the detected bug level is
larger or equal to this value, it will
send the alarm to the network
administrator. This value is in the
range of 1 to 5, 2 by default.
Default
The default lowest bug level for MEP to generate the alarm
is 2.
Command
mode
Privileged EXEC mode.
Usage
guidelines
N/A.
Examples
Ruijie(config)#cfm cfm alarm-priority 3