CLI Reference CFM Configuration Commands
show cfm
linktrance-info
service-instance
Show the linktrace information.
cfm linktrace auto-detection size
Use this command to auto-execute the linktrace function when a peer MEP(maintenance association end point) is
lost.
cfm linktrace auto-detection [size entries-count]
no cfm linktrace auto-detection
The system is able to save the
response information corresponding to
the auto-executed linktrace for
entries-count times in total. The valid
range is 1-100.
Disable the linktrace auto-detection
function.
By default, the entries-count value is 5.
Ruijie(config)# cfm linktrace atuto-detection
show cfm
linktrance
auto-detection
size
Show the response information of the
linktrace auto-detection.
cfm loopback service-instance mep count
Use this command to execute the loopback function.
To Next Page
Loading...
