Ruijie RG-S2600G-I Series - Page 991

CLI Reference REUP Configuration Commands
Default
The default group number is 1.
By default, no mac-address-table update group is
configured.
Command
mode
Interface configuration mode.
Usage
guidelines
In order to reduce the flood due to the MAC address update and the
influence on the normal data transmission of the switch, Ruijie
products add a configuration of MAC address update group. Only if all
the interfaces are added to a MAC address update group, the
downstream data transmission be restored rapidly.
Examples
Ruijie(config-if)# mac-address-table update group 2
Related
commands
Command
Description
show
mac-address-table
update group
detail
Show the mac-address-table update group
information.
switchport backup interface interface-id prefer instance
Use this command to configure VLAN load balancing on a link. The no form of this command is used to delete
the configured VLAN load strategy.
switchport backup interface interface-id prefer instance instance-range
no switchport backup interface interface-id prefer
Parameter
description
Parameter
Description
interface-id
Interface ID of the backup link.
instance-range
Instance range of loading on the backup
interface.
Default
No VLAN load on the backup interface.
Command
mode
Interface configuration mode.
Usage
MSTP instance mapping can be used to modify the mapping between