Ruijie RG-S2600G-I Series - Page 990

CLI Reference REUP Configuration Commands
mac-address-table move update transit vlan
Use this command to enable REUP to transmit the mac-address update messages.
mac-address-table move update transit vlan vid
no mac-address-table move update transit vlan
Parameter
description
Parameter
Description
vid
ID of the VLAN transmitting MAC
address update packets.
Default
Transmit the MAC-address update messages in the default VLAN on
the port.
Command
mode
Interface configuration mode.
Usage
guidelines
When a link is switched, the VLAN enabled to transmit MAC address
update packets will send MAC address update packets to its uplink
device.
Examples
The following example configures VLANs transmitting MAC address
update packets:
Ruijie(config)# mac-address-table move update transit
Related
commands
Command
Description
mac-address-table
move update
transit
Enable REUP to receive the
mac-address-table update messages.
mac-address-table update group
Use this command to set the mac-address-table update group.
mac-address-table update group [ group-num ]
no mac-address-table update group
Parameter
description
Parameter
Description
group-num
The mac-address-table update group
ID.