SATO CL6NX - Page 166

164
Both UTF-8 and UTF-16 encodings are supported. Characters are encoded as surrogate pairs
in UTF-16, and as a 4 byte code in UTF-8. Some encoding processes use CESU-8, which
converts a surrogate pair to UTF-8.
[Notes]
• With the highlighting function, the character width enlarges proportional with the expansion
factor.
• Using the highlighting function, depending on the type of font, characters become squeezed.
• This command is not available for JIS code print data.
• For the half size character specification (1-byte character code), printing will be performed in
W20 x H40 dots.
• For the full size character specification (2-byte character code), printing will be performed in
W40 x H40 dots.
• When the Kanji mode setting is [Japan, Compatible Kanji] or [China, Simplified Chinese
(GB18030)] or [China, Traditional Chinese (BIG5)] or [Korean (KSX1001)], it will be a command
error.
[Attention]
• When half-sized character with voiced/P-sound consonant mark is specified, each part of
character appears as a single character.
e.g.) When the word
"ﾊﾞｰ"
is specified, it will be written separately such as "
ﾊ
", "
ﾞ
", "
ｰ
".
[Valid Commands]
Print position <V> <H>
Modification <P> <L> <%> <&> </> <0> <WD>
Parent topic Font command