491
[ESC+RK] RFID write (FeliCa) (CL4NX Only)
Command ESC RK Parameter
Hexadecimal code <1B>
16
<52>
16
<4B>
16
Refer to Parameters page
Initial value None
When the power is OFF The set command will not be maintained.
Valid range within items The set parameter becomes invalid.
Valid range and term of
command
Valid range between items The set parameter becomes invalid.
[Function]
Specify data to write to FeliCa Lite and FeliCa Lite-S tags.
This command also write to the system area (one time output).
[Format]
[When setting NFC(NDEF) format user data]
<RK>a(,b),D0,(,rga:g~g)(,rgb:h~h)(,rgc:i~i)(,sdk:jj..jj)(,ckv:kkkk)(,df1:llll)(,df2:oooo)
(,eid:pp..pp)(,lck:tt..tt)(,lsy:uu)(,nfc:q)(,spl:x)(,ptl:xx)(,ecd:x)(,lgc:aaaaa...aaaa)(,idt:xxx...xxx)
(,ndd:mmmm,nnnnn...nnnn)(,hma:xxxxxxxxxxxx)(,dnm:aaaaa...aaaa)(,dcl:xxxxxx)(,scl:xxxx)
(,ver:x,x)(,rfb:x)(,ssi:xxx,aaa...aaa)(,nky:xxx,aaa...aaa)(,atp:xxxx)(,etp:xxxx)(,fsw:r)
[When setting free format user data / when there is no user data]
<RK>a(,b),Dmmmm,n~n(,wsb:ee)(,blt:f0,f1~,f12,f13)(,rga:g~g)(,rgb:h~h)(,rgc:i~i)
(,sdk:jj..jj)(,ckv:kkkk)(,df1:llll)(,df2:oooo)(,eid:pp..pp)(,lck:tt..tt)(,lsy:uu)(,nfc:q)(,fsw:r)
• Parameter
Specification of inlet type
a Valid range for models with UF-S923S/UF-S959S module: 4
4: FeliCa Lite / FeliCa Lite-S
Ignore RFID tag error (omissible)
b Valid range: 0 ~ 9
0: Unspecified
This mode stops every time a tag error occurs.
1 ~ 9: Specify how many labels to ignore for RFID tag error
When tag error occurs, retries with next label up to the maximum number of
labels to ignore. With this mode, printer stops when a series of tag errors occur
that exceeds the specified number of errors.
Note:
• If this parameter is omitted, the number of retries set under the menu Interfaces->
RFID->Retries ([DC2]PA’s identifier IF, MAX_RETRY_LABEL) is applied instead
Data input format + number of data to write in bytes
Dmmmm
or
Number of data to write
"D" or "d" shows that this field is
for the number of data to write.
Specifies the number of bytes for the next parameter
“n: data array to write”. This portion should be written
in bytes, so the number specified for this field does
To Next Page
Loading...
Need help?
General
Weight and Dimensions
