723
In case where communication is lost while transferring print data
Note
• The print data cannot be guaranteed if communication through Bluetooth is disconnected while
sending print data.
Make sure to turn off the power of printer, then turn on it again to retransmit the print data.
CRC check is enabled (Common in status 3 and 4)
Receiving/Analysis/Editing
Disconnection timeout period has passed.
*Clear print command that has already been received.
ID number=[05]
Print Qty=50
Job name=[SATO]
CONNECT
Print command (STX to ETX CRC)
××
ENQ
(Status request command)
Status
ID number=[05]
Status=Wait for Receive
Remaining label=[000000]
Print command (STX to ETX CRC)
ID number=[06]
Print Qty=50
Print
Disconnection
or communication failure
ACK
This productHOST
Note
• In case where communication through Bluetooth is disconnected while transmitting print data,
print data that has already been received, will be cleared after disconnection timeout period.
CRC check is disabled (Common in status 3 and status 4)
Receiving/Analysis/Editing
ID number=[12]
Print Qty=50
Job name=[SATO]
CONNECT
This productHOST
Print command (STX to ETX)
××
Disconnection
or communication failure
Note
• Print data cannot be guaranteed if communication through Bluetooth is disconnected while
sending print data as in the figure above. Please resend print data after turning off the power of
printer then on it again.
Parent topic Transmission sequence
To Next Page
Loading...
