SATO CL6NX - [DC2+PI] Application Change

560
[DC2+PI] Application change
Command DC2 PI Parameter
Hexadecimal code <12>
16
<50>
16
<49>
16
,aa
Initial Value None
When turning off the power -
Valid range -
Printer operation in
progress
The command cannot be received during the printer
operation. ([NAK] return)
When acquiring label
sensor information
Commands are not accepted while acquiring sensor
information. ([NAK] reply)
Error The command cannot be received while an error is
occurring. ([NAK] return)
Valid range and term of
command
Others Commands cannot be received other than when the
screen is Online or Offline. ([NAK] return)
[Function]
This command is used to switch applications such as SBPL and SZPL.
[Format]
DC2 (12H) + PI,aa
[Parameters]
Symbol Parameter name Valid range Acquisition method
aa Identifier 00: AUTO
SB: SBPL
SZ: SZPL
SI: SIPL
SD: SDPL
ST: STCL
SE: SEPL
Two characters fixed
acquisition
[Return data format (normal)]
[ACK]<06>
16
[Return data format (when a command error occurs)]
[NAK]<15>
16