424
[ESC+IP5] Antenna output power (UHF M6e) (CL4NX Only)
Command ESC IP5 Parameter
Hexadecimal code <1B>
16
<49>
16
<50>
16
<35>
16
aaa(,bbb)
Initial Value Nil
When turning off the power The set command is maintained.
Valid range within item The set parameter becomes valid.
Valid range and term of
command
Valid range between items The set parameter becomes valid.
[Function]
This command specifies the antenna output power.
The antenna output power for the write command and the antenna output power for the read
command can be set to separate values.
[Format]
<IP5>aaa(,bbb)
• Parameters
aaa = 000 - 240 Antenna output power.
Three-digit number with 10 times the dBm value
bbb = 000 – 240. Antenna output power of the read command.
Three-digit number with 10 times the dBm value (can be omitted)
If you specify only aaa, the antenna output power is set with both the write command and read
command having the same value.
When both aaa and bbb are specified, the antenna output power setting is made by using the
value of aaa for the write command and the value of bbb for the read command.
For details on the actual antenna output power, refer to the antenna output power table.
[Coding Example]
<A>
<IP5>170
<Z>
The antenna output power is changed to 17.0 dBm without restarting the printer, and this value is
maintained even when the printer is turned OFF.
<A>
<IP5>120,090
<Z>
The antenna output power of the write command is changed to 12.0 dBm, and the antenna output
power of the read command is changed to 9.0 dBm without restarting the printer. These settings are
maintained after turning off the printer.
[Supplemental explanation]
•
This command cannot be used in combination with other than <A> and <Z>.
• This command is not processed when receiving during printing. Processed after printing is
completed.
• Since the antenna output power changes, it may not be possible to read or write some tags
depending on their type.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
