SATO CL6NX - [DC2+DB] Initialization

595
[DC2+DB] Initialization
Command DC2 DB Parameter
Hexadecimal code <12>
16
<44>
16
<42>
16
,aa
Initial Value None
When turning off the power -
Valid range -
Printer operation in
progress
The command cannot be received during the printer
operation. ([NAK] return)
When acquiring label
sensor information
Commands are not accepted while acquiring sensor
information. ([NAK] reply)
Valid range and term of
command
Error The command cannot be received while an error is
occurring. ([NAK] return)
[Function]
This command initializes the printer setting.
[Format]
[DC2] DB,aa
[Parameters]
Symbol Parameter
name
Valid range Initialization target Acquisition
method
CA: Common settings
initialization
[PRINTER] section
CB: Warning function
initialization
[COUNT] section
II: IEEE1284 settings
initialization
[IEEE1284] section
IR: RS-232C settings
initialization
[RS-232C] section
IL: LAN settings initialization [LAN] section
IU: USB settings
initialization
[USB] section
IW: WLAN settings
initialization
[WLAN] section
IB: Bluetooth settings
initialization
[BLUETOOTH] section
IE: EXT settings
initialization
[EXT] section
IF: RFID settings
initialization
[RFID] section
a Identifier
IN: NFC settings
initialization
[NFC] section
Two characters fixed
acquisition