236
• Parameter
k [Input mode]
1
:
Numeric mode
2
:
Alphanumeric mode
3
:
Kanji mode (Shift JIS Kanji)
* Specify only when specifying Manual setup in Data setting mode.
* There is binary specification other than above, but data specification command is different.
m [Number of data] = Valid Range
:
1 to 2953
* Specify when specifying Automatic setup in Data setting mode or specifying binary specification
in Manual setup.
n [Print data] = Data
[Format] (Version)
<QV>pp : Use when specifying the version.
• Parameter
pp [Version] = 00 to 40 (MODEL2)
* Use when fix the size of QR symbol by specifying the version. When not specified, it will be
specified automatically. It will be Auto when specifying 00. The parameter error does not arise
in the range from 00 to 40.
* Refer to [QR code version command] for details.
[Supplementary Explanation1]
• When specifying Kanji in <DN>, specify size that is 2 X number of Kanji characters.
• For <DN> in Automatic setup, when 80H to 9FH and E0H to FFH is specified as data, it is
handed as Kanji mode, and cannot specify them as binary.
[Coding Example1]
Error correction level: 7%, Size of one side of cell: 05, Data setup mode: Manual setup,
Concatenation mode: Normal
<A>
<V>100<H>200<2D30>,L,05,0,0
<DS>1,012345
<Q>2
<Z>
[Supplementary Explanation2]
• If the parameter other than the description is specified or number of print data does not match,
printing is not performed.
• Data specification command in data part varies according to parameter setup or specified data.
[Coding Example2]
Error correction level: 7%, Size of one side of cell: 04, Mixed specification of Manual setup (Data
setup mode)
In Manual setup, you can proceed specifying data in specified input mode (Numeric, Alphanumeric,
Kanji, Binary).
<A>
<V>100<H>200
<2D30>,L,04,0,0
<DS>3,SATO
To Next Page
Loading...
Need help?
General
Weight and Dimensions
