241
[Format] (Data part)
Manual setup (Data setup mode)
<DS>k,n...n : Use when input mode specification is Numeric mode, Alphanumeric mode and Kanji
mode.
<DN>mmmm,n...n : Use when specifying by binary.
Automatic setup (Data setup mode)
<DN>mmmm,n...n : Change input mode automatically according to input data.
• Parameter
k [Input mode]
1
:
Numeric mode
2
:
Alphanumeric mode
3
:
Kanji mode (Shift JIS Kanji)
* Specify only when specifying Manual setup in Data setting mode.
* There is binary specification other than above, but data specification command is different.
m [Number of data] = Valid Range
:
1 to 486
* Specify when specifying Automatic setup in Data setting mode or specifying binary specification
in Manual setup.
n [Print data] = Data
[Format] (version)
<QV>pp
:
Specify when specifying the version.
• Parameter
pp [Version] = 00 to 14 (MODEL1)
* This setting is used when fixing the size of QR symbol with the version command. When
not specified, it becomes Auto.
Specifying 00 also becomes Auto. It does not become a parameter error from 00 to 40.
* See [QR code version command] for details.
[Supplementary Explanation1]
• When specifying Kanji in <DN>, specify size that is 2 x number of Kanji characters.
• For <DN> in Automatic setup, when 80H to 9FH and E0H to FFH is specified as data, it is
handed as Kanji mode, and cannot specify them as binary.
[Coding Example1]
Error correction level: 7%, Size of one side of cell: 05, Data setup mode: Manual setup,
Concatenation mode: Normal
<A>
<V>100<H>200<2D31>,L,05,0,0
<DS>1,012345
<Q>2
<Z>
[Supplementary Explanation2]
• If the parameter other than the description is specified or number of print data does not match,
printing is not performed.
• Data specification command in data part varies according to parameter setup or specified data.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
