312
• When parameter d and e does not match number of data, print may not be performed properly.
• When Micro PDF is specified by PDF type, number per symbol is specified by number of data
codeword per line, and accordingly maximum number of data digit is specified. For details, refer
to "Symbol size and number of data" below.
• When specifying Micro PDF by PDF code type, security level is disabled.
[Point]
• Sequential number is not available.
• Specifying print position by automatic line feed is not available.
• Print 00H to FFH is available.
• Format registration is available.
• Enlarging minimum module size improves print quality.
• Increasing security level improves read rate.
• Print height varies depending on the character such as numeric only, alphabet only or mixture of
numeric and alphabets.
[Precautions during use]
• This is the command of the old specification. Recommend the use of <2D10>.
* Symbol size of Micro PDF417 is following 34 types in the table below.
[Symbol size and number of data of MicroPDF417 ]
Symbol size Maximum number of data
Cols(c) Rows(d) Alphabet (A to Z) Numeric Binary mode
11 6 8 3
14 12 17 7
17 18 26 10
20 22 32 13
24 30 44 18
1
28 38 55 22
8 14 20 8
11 24 35 14
14 36 52 21
17 46 67 27
20 56 82 33
23 64 93 38
2
26 72 105 43
6 10 14 6
8 18 26 10
10 26 38 15
12 34 49 20
3
15 46 67 27
To Next Page
Loading...
