SATO CL6NX - Page 337

335
NOTE:
• This command is effective prior to the User mode settings of printer LCD.
• The offset value specified by the start point correction <A3> with the start point correction sign is
not saved. Thus, the offset value specified by the <A3> command is maintained until the change
is made by the next <A3> or the power is off (See [Valid range and saving parameter]).
• The offset value specified by the <A3> command without the sign (+/-) is registered also in
the user mode of the printer LCD. Thus, the offset value specified by the <A3> command is
maintained even the power is off. However this is a format to be compatible with the older
printer models. Please specify the sign (+/-) in normal operation (See [Valid range and saving
parameter]).
[Valid range and saving parameter]
Model Head density Horizontal start point
correction (dots)
Vertical start point
correction (dots)
Saving parameter
203 dpi -831 to +831 -19999 to +19999
305 dpi -1247 to +1247 -17999 to +17999
CL4NX
609 dpi -2495 to +2495 -9599 to +9599
203 dpi
-1215 to +1215
*1
-1339 to +1339
*2
-19999 to +19999CL6NX
305 dpi
-1983 to +1983
*1
-2009 to +2009
*2
-17999 to +17999
[A3 Command Save(S-type)]
setting
Valid:
All parameters (with /without
(+/-) sign) saved
Invalid (initial value):
With (+/-) sign: Not saved
Without (+/-) sign: Saved
*3
*1 Valid range when “Head Base Position” is set to “Standard”.
*2 Valid range when “Head Base Position” is set to “Left-justify”.
*3 The setting "without sign" is only applicable to the old model printers. Please specify the sign (+/-) in normal
operation .
Parent topic System Command