399
[Supplementary Explanation]
• Overwriting registration data is available.
• Specify slot registered with Card Slot for Use <CC> prior to this command <T2> by all means.
• The code to specify in the registration font code address needs to match the Kanji set (<KS>)
and Kanji code (<KC>).
• When use <T2> with another registration command, it may occur error because of capacity
shortage of the memory card.
In this case, register another command in another memory card, or use a memory card having
bigger capacity.
• Data output is as follows.
External file [24x24]
D3
D6
D9
D12
D15
D18
D21
D24
D27
D30
D33
D36
D39
D42
D45
D48
D51
D54
D57
D60
D63
D66
D69
D72
D2
D71
D1
D4
D7
D10
D13
D16
D19
D22
D25
D28
D31
D34
D37
D40
D43
D46
D49
D52
D55
D58
D61
D64
D67
D70
24 dots
dots8dots8dots8
24 dots
D1 D2 D3
D4 D5 D6
D7 D8 D9
D70 D71 D72
When registering the external characters described above, D1 data becomes <00>
16
, D2 data
becomes <3C>
16
and D3 data becomes <00>
16
because D1 consists of [00000000], D2 consists
of [00111100] and D3 consists of [00000000].
In the same manner, D4 becomes <00>
16
, D5 becomes <3C>
16
and D6 becomes <00>
16
, and
the external registration data are specified to <003C00003C00…> and up to D72.
[Note]
• Do not turn the printer's power off when accessing to the memory. When the printer power is off
while memory accessing, the data in the accessed media may be corrupted.
Parent topic Memory Card Command
To Next Page
Loading...
Need help?
General
Weight and Dimensions
