431
• In case if tag data could not be read, error message will be printed and will retry with the next
label or discard depending on the retry/release setting.
• This command does not support reprinting with reprint command<C>, external reprint signal or
reprint key.
• In case of a command error due to erroneous format of print job that includes this command,
printer will not print label (so as not to waste label) but will ring the buzzer once short to go to
OFFLINE. The label will not be printed as long as the reason of command error is not removed.
• In case if the settings are made to ignore the sensor, this command will have command error.
• The only barcode type allowed in <B> (ratio 1:3) and <D>(ratio 1:2) is "1:CODE39".
• QR code <2D30>, <2D31> are available, but they cannot be specified in numerical mode and
Kanji mode. Micro QR code are not available due to limitations in the number of data.
• The maximum number of print elements (valid commands that include ID) to be converted
for this command is 20. Avoid exceeding this maximum. When exceeded, the exceeded print
element may become erroneous data.
• When the number of digits required to make a valid print command (e.g. a barcode) exceed the
number of digits received from the RFID tag, supplementary digits must be padded to create a
valid command.
Example:
<TU>1, 01000003SATO
<BI>020502SATO0
• The available type of ANK character font with <RH> are as follows under the current
specification:
SATO CG Sleek
SATO CG Stream
SATO OCRA
SATO 0
SATO ALPHABC
SATO BETABI
SATO FOLIOB
SATO FUTURAMC
SATO GAMMA
SATO OCRB
SATO SANS
SATO SERIF
SATO VICA
Parent topic RFID Command (CL4NX Only)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
