SATO CL6NX - Page 435

433
Symbol Parameter name Valid range
* Specified in text format
[Format of EPC/TID return data]
“Specify memory” + “:” + “Data” + “Line feed(0DH, 0AH)”
ee:f…f(,gg:h…h)[CR][LF]
Specifying the memory to be record
[DC2]PA-printer setting IF:RFID setting section parameter
DATA_TO_RECODE : read data depends on RFID data record as below.
"0": BOTH (EPC and TID are returned)
"1": EPC (only EPC is returned)
"2": TID (only TID is returned)
Below is the sample of [DC2]PA setting.
[DC2]PA,24,IF,18,DATA_TO_RECODE:0[CR][LF]
To set the above from settings menu, you can do the same from [Interface] > [RFID] > [Data to
Record]
[EPC/TID return data]
Symbol Parameter name Valid range
e(g…) Memory EP : EPC
ID : TID
f(h…) Data Maximum 256 digits
Data Example)
EP:E0123456789ABCDEF0123456,ID:E200680612345678
[Return data format (when a command error occurs)]
[NAK]<15>
16
[Exception processing]
Exception conditionParameter name
A value outside the range is specified The specified size and
received size are different
Identifier Command error Invalid receive data
Terminology Description
Command error The data received after a command error is determined is not
considered as a parameter of this command.
Invalid receive data The data corresponding to Byte 2 and thereafter of the identifier is
ignored.
[Coding example]