448
• When you specify the user ID by using <DN> in the data part during the use of 2D codes,
specify the number of characters of the user ID in the number of data items.
Example :
<TU>1,SATO
<DN>0004,SATO
• This command will not be executed while the printer is printing. It will be executed after the print
is complete.
• This command is enabled in sequential printing, cutter (backfeed after print), dispenser
(backfeed after print).
It cannot be used in tear-off mode, cutter (backfeed before print) and dispenser (backfeed
before print).
• This command will not work correctly if the tag offset is set anywhere other than default position.
• In case if UID data could not be read, error message will be printed and will retry with the next
label or discard depending on the maximum retry setting.
• Do not specify 2 for parameter a when using ISO/IEC 15693 tag. Two is dedicated for ISO/
IEC14443 TypeA. So the number of UID readout digits will be limited to 14.
• The only barcode type allowed in <B> (ratio 1:3) and <D>(ratio 1:2) is "1:CODE39".
• QR code <2D30>, <2D31> are available, but they cannot be specified in numerical mode and
Kanji mode. Micro QR code are not available due to limitations in the number of data.
• The maximum number of print elements (valid commands that include ID) to be converted
for this command is 20. Avoid exceeding this maximum. When exceeded, the exceeded print
element may become erroneous data.
• The available type of ANK character font with <RH> are as follows under the current
specification:
SATO CG Sleek
SATO CG Stream
SATO OCRA
SATO 0
SATO ALPHABC
SATO BETABI
SATO FOLIOB
SATO FUTURAMC
SATO GAMMA
SATO OCRB
SATO SANS
SATO SERIF
SATO VICA
Parent topic RFID Command (CL4NX Only)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
