47
[Supplementary Explanation]
• When the value outside of the range is specified for sectional number, it will be processed as
"0". (This will not be a command error.)
• When the value outside of the range is specified for the designation of pattern, it will be
processed as "0". (This will not be a command error.)
• Even when the print start position exceeds the printing area, the printing is performed. (This will
be a command error.)
• This command sets the base reference point to the center of a circle.
<V>200
<H>200
0,0
100 in radius
• This command can be registered to the format.
• If setting the grid line wider, it will be widened inward.
[Valid Range]
Valid range (dots)
Radius Line width
5 to 999 1 to 999
Parent topic Modification Command
To Next Page
Loading...
