552
[Precautions during use]
• The printer device information update cycle must be five seconds or longer. When sending this
command in continuation, be sure to set an interval of five seconds or more.
• When a USB memory is used, only the available space of the memory connected first is
returned even when a connection is established via the HUB.
• It takes more than one second to create the return data immediately after the startup in order to
obtain the checksum of the module.
• It takes more time to create the return data when there are a lot of registrations by SBPL
command. (It takes approx. 1.5 seconds to register 10,000 data.)
　　
　　
DC2 + PC
STX + a…a,b…b:c…c[CR][LF](d…d:e…e[CR][LF]) … + ETX
Host
This product
Parent topic Common commands for all languages
To Next Page
Loading...
