SATO CL6NX - Page 556

554
[Sensor information data list]
No. Sensor information name Description Sensor information data
1 IM I-Mark sensor X.X/SLY.Y
X.X = 0.0 to 3.3 : Sensor level
Y.Y = 0.0 to 3.3 : Slice level
2 GAP Gap sensor X.X/SLY.Y
X.X = 0.0 to 3.3 : Sensor level
Y.Y = 0.0 to 3.3 : Slice level
3 HEAD OPEN Head Open 0: Close, 1: Open
4 CUTTER OPEN Cutter open 0: Close, 1: Open
5 DISPENSER Dispense sensor 0: Without label, 1: With label
6 HEAD TEMP Head thermistor -XX to XX: Thermistor
temperature
7 RIBBON Ribbon slit sensor 0: Slit ON, 1: Slit OFF
8 SENSOR HIGH High value of active sensors X.X = 0.0 to 3.3 : Sensor level
9 SENSOR LOW Low value of active sensors X.X = 0.0 to 3.3 : Sensor level
[Note]
• When sending this command in continuation, be sure to set a fixed interval (100 msec or more).
• If the sensor information acquisition processing for each sensor does not finish within 100 msec,
a timeout is thought to have occurred, and [NAK] is returned. A timeout may occur during the
printer operation.
• SENSOR HIGH, SENSOR LOW is the value of the last label that passed through the sensor.
Therefore it may sometimes be different from test printing results (the value is measured with
the label before printing).
• If the sensor type is set to NONE, the SENSOR HIGH and SENSOR LOW values return as 0.0.
DC2 + PD
STX + a…a,b…b:c…c,(d…d:e…e) … + ETX
Host
This product
Parent topic Common commands for all languages