SATO CL6NX - Page 627

625
Description ASCII HEX
RIBBON / LABEL NEAR END & BUFFER NEAR
FULL
*1
V 56
(UNUSED) BATTERY NEAR END
*1
- 2D
(UNUSED) BATTERY NEAR END & RIBBON NEAR
END
. 2E
(UNUSED) BATTERY NEAR END & BUFFER NEAR
FULL
/ 2F
(UNUSED) BATTERY NEAR END & RIBBON NEAR
END & BUFFER NEAR FULL
@ 40
BUFFER OVER
*2
a 61
HEAD OPEN b 62
PAPER END c 63
RIBBON END d 64
MEDIA ERROR e 65
SENSOR ERROR f 66
BARCODE READ / MATCHING ERROR f 66
BARCODE READER CONNECTION CHECK ERROR f 66
HEAD ERROR g 67
(UNUSED) COVER OPEN h 68
CUTTER OPEN ERROR h 68
(UNUSED) RIBBON CORE NON LOCK ERROR h 68
CARD ERROR i 69
CUTTER ERROR j 6A
OTHER ERRORS k 6B
(UNUSED) CUTTER SENSOR ERROR l 6C
(UNUSED) STACKER OR REWINDER FULL WINDER FULL m 6D
RFID TAG ERROR o 6F
RFID PROTECT ERROR p 70
ERROR
DETECTION
(UNUSED) BATTERY ERROR q 71
*1 Depending on the timing of analysis/editing, print quantity may not be set up properly
*2 Occurring of buffer over depends on the interfaces
RS-232C USB LAN WLAN Bluetooth IEEE1284
○ x x x x x
[○：
Interface which has buffer over,
×：
Interface which doesn’t have buffer over]
2) Cancel request command
This command enables to cancel print jobs and to clear the entire contents of receive buffer.
The status of this product after finishing process is returned.
* When the cancel request command has been sent, wait more than 500 ms before sending the next data.