Section 04 ENGINE (2-STROKE)
Subsection 04 (TOP END)
All Engines except 947 DI
– Remove both spark plugs and bring one piston
to Top Dead Center a using a TDC gauge.
1
F01D2IA
1. Bring piston to TDC
947 DI Engines
– Remove both direct injectors and bring one pis-
ton to Top Dead Center using a TDC gauge.
Keep spark plugs in their holes.
All Engines
– Obtain a graduated burette (capacity 0 - 50 cc)
and fill with an equal part (50/50) of gasoline and
injection oil.
F00B0BA
1
1. Graduated burette (0 - 50 cc)
– Open burette valve to fill its tip. Add liquid in
burette until level reaches 0 cc.
– Inject the burette content through the spark
plug hole on all engines except 947 DI and
through direct injector hole on DI engines until
liquid touches the top hole.
F00D0HA
1
1. Top of spark plug hole
NOTE: The liquid level in cylinder must not drop
for a few seconds after filling. If so, there is a
leak between piston and cylinder. The recorded
volume would be false.
– Let burette stand upward for about 10 minutes,
until liquid level is stabilized.
– Read the burette scale to obtain the quantity of
liquid injected in the combustion chamber.
126 smr2004-Complete Line Up
To Next Page
Loading...
