SeaDoo GTI - Page 172

Section 04 ENGINE (2-STROKE)
Subsection 05 (BOTTOM END)
787 RFI Engines
Apply Loctite 518 on screw threads and Molykote
111 below head screws.
Torque crankcase screws to 12 N•m(106lbf•in)
as per following sequence. Repeat procedure,
retightening all screws to 24 N•m(17lbf•ft).
11
F15D05B
7 21 1 3 22 5 9
819 12 17 13 15 4
2
16 14 18
6
20 10
As a final step, torque only M10 screws no. 8 of
crankcase to 40 N•m(30lbf•ft) as per following
sequence.
F15D05C
11 7 1 3 5 9
812 4
6
102
947 DI Engines
Apply Molykote 111 below head
of screws and
Loctite 518 on threads.
Torque crankcase screws to 12 N•m(106lbf•in)
as per following sequence. Repeat procedure,
retightening all screws to 27 N•m(20lbf•ft).
F07D09E
7
3
1
16
5
19
22
11
10
8
24
21
15
4
13
2
18
6
23
12
14
9
20
17
As a final step, torque only the M10 x 73.5 bolts
to 40 N•m(30lbf•ft) as per following sequence.
F07D09C
9
7
3
1
5
11
10
8
4
2
6
12
Oil Fittings
717 and 787 RFI Engines
If inlet and outlet oil fittings no. 11 of rotary valve
shaft have been removed from crankcase, reinstall
them with their end pointing toward ignition hous-
ing. Apply Loctite 518 on threads of fittings.
150 smr2004-Complete Line Up
www.SeaDooManuals.net