Section 05 ENGINE (4-TEC)
Subsection 02 (INTAKE SYSTEM)
F18E0PA
1
1. Lift lock tab
Then proceed with the tab under the tube. Refer
to the following illustration to see it.
1
F18E0QA
1. Other lock tab under tube
Unlock coolant expansion tank, pull out then move
away.
2
F18E1MA
1
Step 1: Push tab (each side) to release
Step 2: Pull tank out
Remove vent tube support.
NOTE: Pay attention not to drop the nuts under
support when removing screws.
2
1
F18L1GA
2
3
1. Vent tube support
2. Remove retaining screws
3. Pay attention to nuts underneath
RXP 4-TEC Models
Remove engine cover. Refer to HULL AND BODY.
All Models
Remove oil dipstick.
Pull fuel rail cover out.
Release the fuel pressure in the system, refer to
ENGINE MANAGEMENT section.
Disconnect battery cables from battery.
192 smr2004-Complete Line Up
To Next Page
Loading...
