Section 08 ENGINE MANAGEMENT (4-TEC)
Subsection 01 (OVERVIEW)
NOTE: If desired, a safety lanyard can be used on
other watercraft equipped with the DESS. It only
needs to be programmed for thet watercraft.
When connecting a safety lanyard cap on the post,
the DESS is activated and will emit audible signals:
– 2 short beeps indicate a working safety lanyard.
Engine starting can take place.
– 1 long beep indicates a wrong safety lanyard
is being used or that something is defective.
Engine starting is not allowed.
The ECM features a self-diagnostic mode. Refer
to DIAGNOSTIC PROCEDURES section for more
information.
Engine Starting
If the ECM recognizes a valid safety lanyard, it
allows engine to start when the start/stop button
is pressed.
If start/stop button is held after engine has started,
the ECM automatically stops the starter when the
engine speed reaches 1600 RPM.
If start button is activated while the throttle lever
is depressed more than 65%, the engine will not
beallowedtostart.
Engine RPM Limiter
The ECM will limit the maximum engine speed.
Engine Stopping
Thereare2waystostoptheengine.
Press and hold start/stop button or remove the
safety lanyard cap from its post.
Low-Oil Pressure Warning Device
When the oil pressure falls under a certain level,
the ECM sends out signals to the beeper and to
the information center gauge. Additionally the en-
gine goes in limp home mode.
High Coolant Temperature and
EGTS Warning Device
When the coolant temperature or the exhaust gas
temperature is getting to high, the ECM sends out
signals to the beeper.
398 smr2004-Complete Line Up
To Next Page
Loading...
Need help?
General
