SeaDoo GTI - Page 460

Section 08 ENGINE MANAGEMENT (4-TEC)
Subsection 03 (DIAGNOSTIC PROCEDURES)
RESPONSIBLE MODULE
FAULT
CODE
INFORMATION
CENTER
MPEM ECM
BEEPER
CODE
WARNING
LIGHT
MESSAGE
DISPLAYED
(info ctr)
FAULT
DETECTED
WHILE ENGINE
NOT RUNNING
FAULT
DETECTED
WHILE ENGINE
RUNNING
LIMP
HOME
MODE
NORMAL
OPERATION
RESUME
WHEN...
P0232 — —
Fuel pump
shortedto12V
15 Flash
CHK
ENG
N Y N
Fault is
recovered
Possible cause:
Damaged pump, damaged circuit wires, damaged connector or damaged ECM output pins.
Service action:
Check for approximately 1 ohm between pins A and D of the fuel pump connector.
Check for damaged circuit wires.
Check for approximately 1 ohm between pins 1-26 and B-29.
Check for damaged connector, damaged ECM output pins or ECM failure.
P0261 — —
Inj. #1 short-
circuit to ground
or open circuit
15 Flash
CHK
ENG
N Y N
Fault is
recovered
Possible cause:
Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins.
Service action:
Check for 11.4 to 12.6 ohms between engine connector pin 1 and ECM connector pin 15.
Check for 12 volts on pin 2 of injector connector.
P0262 — —
Inj. # 1
short-circuit to
12 V
15 Flash
CHK
ENG
N Y N
Fault is
recovered
Possible cause:
Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins.
Service action:
Check for 11.4 to 12.6 ohms between engine connector pin 1 and ECM connector pin 15.
Check for 12 volts on pin 2 of injector connector.
P0264 — —
Inj. #2 short-
circuit to ground
or open circuit
15 Flash
CHK
ENG
N Y N
Fault is
recovered
Possible cause:
Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins.
Service action:
Check for 11.4 to 12.6 ohms between engine connector pin 2 and ECM connector pin 33.
Check for 12 volts on pin 2 of injector connector.
P0265 — —
Inj. #2 short-
circuit to 12 V
15 Flash
CHK
ENG
N Y N
Fault is
recovered
Possible cause:
Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins.
Service action:
Check for 11.4 to 12.6 ohms between engine connector pin 2 and ECM connector pin 33.
Check for 12 volts on pin 2 of injector connector.
smr2004-Complete Line Up 451
www.SeaDooManuals.net