SeaDoo GTI - Page 480

Section 09 COOLING SYSTEM Subsection 01 (CIRCUIT, COMPONENTS AND CARE)
Cooling System
Indicator (CSI)
Engine water
return hose
from tuned
pipe water
jacket
Engine water
supply hose
from jet pump
Drain hose
(lowest point
of circuit)
Water injected
into muffler to
cool exhaust
components
Temperature sensor
activates monitoring
beeper when
temperature
exceeds
80°C (176°F)
Water flows out
of tuned pipe
water jacket
Water flows out
of exhaust
manifold water
jacket and through
tuned pipe
water jacket
before exiting
the tuned pipe
Water injected in
the tuned pipe
controlled by the
water flow
regulator valve for
noise reduction
and performance
improvement
Side
of hull
Air
compressor
silencer
Quick connect
hose fitting
for easy engine
draining
Temperature
sensor activates
monitoring beeper
when temperature
exceeds
100°C (212°F)
Air
compressor
Water flows through
water jackets to cool the
air compressor
Magneto
cover
Crankcase
Water flows
through water
jackets
to cool the
magneto area and
the crankcase
F08E0US
472 smr2004-Complete Line Up
www.SeaDooManuals.net