Section02MAINTENANCE
Subsection 02 (FLUSHING AND LUBRICATION)
1
F01H7CA
717 ENGINE
1. Grounding device
1
F01H7DA
787 RFI AND 947 DI ENGINES
1. Grounding device
Remove both spark plugs and spray BOM-
BARDIER LUBE lubricant into each cylinder.
GTI/GTI LE Models
Connect safety lanyard cap to the post.
Crank the engine a few turns to distribute the oil
onto cylinder wall.
GTI RFI/GTI LE RFI Models
Remove safety lanyard from its post.
Depress the throttle lever at full throttle position
and hold.
Reinstall the safety lanyard cap on its post.
Crank the engine a few turns to distribute the oil
on cylinder wall.
NOTE: Proceeding in this order, no fuel will be
injected into the engine.
XP DI Model
To prevent fuel to be injected and also to cut the
ignition at the engine starting, proceed as follows.
While engine is stopped, fully depress throttle
lever and HOLD for cranking.
Wait 2 seconds then press the start/stop button
to crank the engine a few turns and distribute the
lubricant onto cylinder walls.
NOTE: A 1 second beep every second indicates
the drowned mode is active.
Crank the engine a few turns to distribute the oil
on cylinder wall.
All Models except 4-TEC
Apply anti-seize lubricant on spark plug threads
then reinstall them.
Properly reconnect spark plug cables to spark
plugs.
WARNING
On DI models always reconnect spark plug
cables at the same spark plugs where they
come from. The cable coming out the edge
of the electrical box must be connected to the
MAG side spark plug.
F17L19A
1
XP DI MODEL
1. MAG side spark plug cable
Wipe up any residual water from the engine.
Reinstall plug on air intake silencer cover (if so
equipped,on717 and 787 RFI engines).
NOTE: Enginefoggingshouldbedonewith
BOMBARDIER LUBE lubricant whenever the
watercraft is to be stored for a few days or a long
period.
CAUTION: Never leave rags or tools in the en-
gine compartment or in the bil
ge.
smr2004-Complete Line Up 29
To Next Page
Loading...
Need help?
General
