Section 14 STEERING SYSTEM
Subsection 01 (STEERING SYSTEM)
Torque screw to 7 N•m(62lbf•in).
Install cap no. 2.
WARNING
Correct torque must be strictly followed.
F02K0KA
1
2
4
53
1. Grip insert
2. Grip
3. Flat washer
4. Torque screw to 7 N•m(62lbf•
in)
5. Cap
CAUTION: Ensure to install flat washer other-
wise screw will damage grip end.
Ball Joint
Secure the steering cable ball joint no. 21 to the
nozzle as per following illustration.
CAUTION: Ensure the ball joint is parallel
(± 10°) to the nozzle arm.
F06K01A
1
2
TYPICAL
1. Ball joint on top of steering arm
2. Torque nut to 7 N•m(62lbf•
in)
STEERING ALIGNMENT
For steering alignment procedure, refer to ALIGN-
MENT.
smr2004-Complete Line Up 701
To Next Page
Loading...
