Issue 01/06 Function Diagrams
MICROMASTER 440 Parameter List
6SE6400-5BB00-0BP0
283
- 4170 -
Function diagram
87654321
4170_ZSW1.vsd
Technology Functions
MICROMASTER 440
16.01.2006 V2.1
Status word 1 (r0052)
1)
The sequence control is the internal
control (software) for realizing the drive
status (r0002)
CO/BO: Act StatWd1
r0052
r0052
1 03 25 47 6
9 8
11 1013 1215 14
Segment Bit
Segment Bit
Seven-segment display
Sequence control 1)
Sequence control 1)
Messages
Messages
Messages
Messages
Sequence control 1)
Sequence control 1)
Sequence control 1)
Sequence control 1)
Sequence control 1)
Braking control
Sequence control 1)
Alarm processing
Messages
Messages
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
0
Bit No. Meaning
1 = Drive ready
0 = Drive not ready
1 = Drive ready to run (DC link loaded, pulses disabled)
0 = Drive not ready to run
1 = Drive running (voltage at output terminals)
0 = Pulses disabled
Parameter r0052
1 = Drive fault active (pulses disabled)
0 = No fault
0 = OFF2 active
1 = No OFF2
0 = OFF3 active
1 = No OFF3
1 = ON inhibit active
0 = No On inhibit (possible to switch on)
1 = Drive warning active
0 = No warning
0 = Deviation setpoint / act. value
1 = No deviation setpoint / act. Value
1 = PZD control (always 1)
1 = Maximum frequency reached
0 = Maximum frequency not reached
0 = Warning: Motor current limit
1 = Motor current limit not reached
0 = Motor overload
1 = No Motor overload
1 = Motor runs right
0 = Motor does not run right
0 = Inverter overload
1 = No inverter overload
1 = Motor holding brake active
0 = Motor holding brake not active
1
(x.x)
P0731..P0733
r0052.03
r0052
Signal "Fault active" is inverted by
MICROMASTER if connected to a digital
output which means that the relay will be
in the de-energised state.
To Next Page
Loading...
