Web server
12.6 Standard Web pages
S7-1200 Programmable controller
1018 System Manual, V4.2, 09/2016, A5E02486680-AK
The Start page displays a representation of the CPU or CP to which you are connected and
lists general information about the device and the TIA Portal version you used to download
the project to the CPU. For the CPU, you can use the buttons to change the operating mode
and flash the LEDs, if you have logged in (Page 1013) with the "change operating mode"
privilege (Page 1005).
The bottom portion of the screen is visible if you have configured and installed Web server-
enabled CP modules (Page 1010) in the local rack with the S7-1200 CPU. You can hover
over and click a Web server-enabled CP module to access the standard Web pages. Refer
to the documentation for your CP module for information about the CP module Web pages.
You see the name of the CP module when you hover over it.
The Web server also displays any other CM and CP modules in the local rack, but you
cannot click them as they do not contain Web pages. The module appearance for these CMs
and CPs are light gray (desensitized) to indicate that they are display-only and not clickable
modules.
Note that the S7-1200 fail-safe CPUs display additional data on this page related to
functional safety.
To Next Page
Loading...
