Siemens SIMATIC S7-1200

Technical specifications
A.10 Analog signal modules (SMs)
S7-1200 Programmable controller
1464 System Manual, V4.2, 09/2016, A5E02486680-AK
A.10.2
SM 1232 analog output module specifications
Table A- 145 General specifications
Technical data
SM 1232 AQ 2 x 14 bit
SM 1232 AQ 4 x 14 bit
Article number
6ES7232-4HB32-0XB0
6ES7232-4HD32-0XB0
Dimensions W x H x D (mm) 45 x 100 x 75
Weight
180 grams
Power dissipation 1.8 W 2.0 W
Current consumption (SM Bus)
80 mA
Current consumption (24 V DC)
45 mA (no load)
Table A- 146 Analog outputs
Technical data
SM 1232 AQ 2 x 14 bit
SM 1232 AQ 4 x 14 bit
Number of outputs
2
4
Type
Voltage or current
Range
±10 V, 0 to 20 mA, or 4 mA to 20 mA
Resolution Voltage: 14 bits
Current: 13 bits
Full scale range (data word) Voltage: -27,648 to 27,648 ; Current: 0 to 27,648
Refer to the output ranges for voltage and current (Page 1472).
Accuracy (25 °C / -20 to 60 °C)
±0.3% / ±0.6% of full scale
Settling time (95% of new value) Voltage: 300 μs (R), 750 μs (1 uF)
Current: 600 μs (1 mH), 2 ms (10 mH)
Load impedance Voltage: ≥ 1000 Ω
Current: ≤ 600 Ω
Maximum output short circuit current Voltage mode: ≤ 24 mA
Current mode: ≥ 38.5 mA
Behavior on RUN to STOP
Last value or substitute value (default value 0)
Isolation (field side to logic) none
Isolation (24 V to output)
none
Cable length (meters)
100 m twisted and shielded
Table A- 147 Diagnostics
Technical data
SM 1232 AQ 2 x 14 bit
SM 1232 AQ 4 x 14 bit
Overflow/underflow
Yes
Short to ground (voltage mode only) Yes
Wire break (current mode only)
Yes
24 V DC low voltage
Yes