Technical specifications
A.22 Companion products
S7-1200 Programmable controller
1552 System Manual, V4.2, 09/2016, A5E02486680-AK
The CM CANopen module is a plug-in module between the SIMATIC S7-1200 PLC and any
device running CANopen. The CM CANopen can be configured to be both master or slave.
There are two CM CANopen modules: the CANopen module (article number 021620-B), and
the CANopen (Ruggedized) module (article number 021730-B).
The CANopen module provides the following features:
● Able to connect 3 modules per CPU
● Connects up to 16 CANopen slave nodes
● 256 byte input and 256 byte output per module
● 3 LEDs provide diagnostic information on module, network, and I/O status
● Supports storage of CANopen network configuration in the PLC
● The module is integratable in the hardware catalogue of the TIA Portal configuration suite
● CANopen configuration via included CANopen Configuration Studio (included) or via any
other externanal CANopen configuration tool
● Complies to the CANopen communication profiles CiA 301 rev. 4.2 and the CiA 302 rev.
4.1
● Supports transparent CAN 2.0A for custom protocol handling
● Pre-made function blocks available for each PLC programming in TIA portal
● CM CANopen modules include; DSUB with screw terminals for subnetwork. CM
CANopen configuration studio CD, and USB configuration cable
For more information about this product and for the product documentation, refer to the
product catalog web site for the CM CANopen.
RF120C communications module
The RF10C allows Siemens RFID and code reading systems to be connected directly and
easily to an S7-1200. The reader is connected to the RF120C via a point-to-point connecton.
Up to three communications modules can be connected to an S7-1200 to the left of the CPU.
The RF120C comminications module is configured via the TIA Portal. The article number for
the RF120C communications module is 6GT2002-0LA00.
For more information about this product and for the product documentation, refer to the
product catalog web site for the RF120C.