Device configuration
6.8 Configuring the parameters of the modules
S7-1200 Programmable controller
176 System Manual, V4.2, 09/2016, A5E02486680-AK
Project language correspondence to user interface language in the Web server
The Web server supports the same user interface languages as the TIA Portal; however, it
only supports up to two project languages. You can configure the Web server to use one of
two project languages for diagnostic buffer text entries depending on the user interface
language of the Web server. You configure these settings in the "Multilingual support"
properties in the device configuration of the CPU. (Network comments and block comments
and other multilingual texts are not visible from the Web server.)
In the Multilingual support properties, the user interface languages on the right are not
editable. They are the pre-defined languages that are available for both the TIA Portal and
for the Web server user interfaces. The "Assign project language" setting is configurable and
can be one of two of your configured project languages, or it can be "None". Because the
S7-1200 CPU only supports two project languages, you cannot configure the project
language to be the same as the user interface language for all of the supported user
interface languages.
In the configuration below, the Web server displays diagnostic buffer entries (Page 1022) in
German when the Web server user interface is German, displays no texts for diagnostic
buffer events when the Web server user interface is Spanish, and displays diagnostic buffer
entries in English for all other languages.
To Next Page
Loading...
